Welcome to filtsai.com! | Home | Contact | Register | Login | ||||
Christ | Cars | Woodworking | Condo | Nutrition | Wifetest | Pictures | Japan | ||||
Cooking: savory | sweet | techniques | uncategorized | all recipes | ||||
View Blargh
The one problem is that the old rotors are attached by 2 phillips screws. They should be torqued to about 80ft-lbs, which is very high, and you can't use a wrench, only a screw driver. Now, if you understand torque and that a screw driver usually has a 1" thick handle, a better torque estimate would be 960 in-lbs. When's the last time you could exert 960 pounds of force with your hand/wrist? And don't forget to take into account 7 year of corrosion. So, to address this issue, I picked up an electric impact wrench. I've been wanting an air compressor and pneumatic impact wrench for a while, but a decent compressor costs $200+ ($300+ for a good one) plus $50-$150 for the wrench. Then I found a DeWalt electric impact wrench (DW290) which costs $179. Some reviews have said it's a great addition and much easier than the air compressor route. Unfortunately some people think it's 275ft-lbs of torque is a bit low. I decided to get one anyway just to try it out. I almost got one at Home Depot but it's a good thing I didn't. I found a 10% off coupon for Lowe's where I found it for the same price. However, when I looked on the shelf, they also had the DW292, which I believe is the new model with 345ft-lbs instead of 275. In addition to the additional power, the price was the same. Excellent. Posted 05/09/2005 09:48 PM in Uncategorized | Total Comments: (3) Link To This Blargh Comments
When some people talk about guys and their tools, cars, and electronics, they picture you in their minds. Submitted by Cliff on 05/10/2005 01:18 AM qISuCuRlxjcXFgMBN hi kxm0bh5asopga401 good luck Submitted by FuKZyKCsQtEZs on 01/09/2009 08:33 PM YeMSUEZaFmRXlEQmjQ hi kxm0bh5asopga401 good luck Submitted by osZOKtKWhM on 01/11/2009 09:09 AM Add Comment
|
|||||||||